Regal 53 SC Owner's Manual page 271

HANGING LOCKER LIGHTS
Notched Area Here
Under Cover
Lens Cover Removed
To change a hanging locker light bulb follow these steps:
 Remove the lens cover from the lamp base. There is a
tab on the bottom of the lens cover. Push the lens cover
at this point to remove the lens cover.
Remove the defective bulb.
Replace the bulb.
Reinstall the lens cover by snapping it in place.
READING LIGHTS
To change a reading light bulb follow these steps:
Remove the lens cover from the lamp base by turning
the lens cover counterclockwise slightly and while in this
position pull the lens cover out at the lamp body notches.
 Remove the defective bulb by turning it counter-
clockwise. and pulling it up. Works much like an automotive
style tail light bulb.
 Replace the bulb by pushing down and turning the
bulb in a clockwise direction until it hits the stop.
 Reinstall the lens cover by fi rst lining it up with the
notches on the lamp body. Let the lens cover/body enter
the notched area and then lock it in place by turning the
lens cover clockwise.
10
Chapter 7