Regal 53 SC Owner's Manual page 179

Chartplotter
multifunction display, pre-loaded with U. S. coastal maps
and interfaces with other electronic components through
the Garmin Marine Network. It displays graphics with
crisp, video-quality resolution. With the dual chartplot-
ters and the optional 4 camera monitoring system, you
can keep tabs of your engine room, forward and aft decks
along with the main salon on the chartplotter.
In addition, the plotter(s) can integrate sonar, apps, en-
gine data and media with the ability to control the Fusion
system where link enabled.
As mentioned before some yachts display the optional
dual chartplotters.
Before operating the chartplotter(s) read and understand
the vendor supplied owner's manual including all the
warning information found in the owner's information
packet. This info is usually located in the port aft lower
locker of the master stateroom or go www.garmin.com.
Using the touchscreen
1. Tap the screen to display an item.
2. Swipe or drag your fi nger across the screen to scroll or
pan.
3. Pinch two fi ngers together to zoom out.
4. Spread two fi ngers apart to zoom in.
To insert a memory card refer to the Garmin chartplot-
ter owner's manual. You can use optional map cards for
satellite imagery or variou reference points. Also, blank
memory cards can transfer data to another compatible
Garmin plotter or a computer.
Single chartplotters are stan-
dard on your yacht Dual
chartplotters are optional
but are required for a por-
tion of the other electronic
options. The unit(s) feature
a 12" diagonal touchscreen,
NMEA 2000 compatible,
Note the positions of the power key and backlight sensor.
Select Setttings>System>Beeper and Display>Backlight
To adjust the color mode:
Settings>System>Display>Color Mode. Then select an
option.
A. To power the system up turn the "house" battery
switch to the "on" position at the battery management
panel.
B. Next, turn the helm electronics switch to the "on"
position. This powers up the GPS antenna and the auto
pilot. The chartplotter(s) is now ready to power up.
C. Momentarily press and release the chartplotter power
button.
Note: If dual chartplotters are installed, you can power
up either one by momentarily pressing and releasing the
power button or by pressing and releasing both power
buttons. A message appears which needs to be acknowl-
edged.
D. On powering OFF, press the power button on each
chartplotter.
127
Systems