Regal 53 SC Owner's Manual page 104

DOCKSIDE CORD REEL OPTION
Select yachts feature a powered
cord reel system for reeling in the
dockside cord. The dockside cord
is rated at 50 amps and is attached
to a reel which releases the needed
cord length when pulled out. The
power cord is accessible from just
above the aft platform. The reel is
located in the aft bilge. The power
cord retrieval is accomplished by
pushing a switch which powers the
12 volt DC motor.
The yacht end of the cord is directly
wired into the cord reel. Therefore, there is nothing to be
plugged into the yacht.
The marina end must be plugged into the marina dock
power center using the same procedure as the standard
dockside cord.
Note:
If the cord reel system option is ordered with an isolation
transformer option the cord is confi gured from the cord
reel manufacturer without the neutral wire and prong
because the isolation transformer actually produces the
"neutral" on board by magnetic induction.
If the cord reel system option is ordered in boats without
the isolation transformer the cord is confi gured with the
normal 50 amp male footprint (includes a neutral wire).
50 AMP 50 AMP
DOCKSIDE DOCKSIDE
CORD CORD
INLET INLET
The illustration above shows a typical transom layout
with the optional cord reel system. When disconnected
make sure to close and secure the inlet cover plate.
52
Chapter 4
INLET INLET
COVER COVER
PLATE PLATE
WARNING WARNING
LABEL LABEL