Regal 53 SC Owner's Manual page 203

DTS CONTROL-BASIC FUNCTION OVERVIEW
Sync:
The Sync engages automatically at key-up. The Sync mode
feature monitors both control lever positions. If both le-
vers are within 10% of each other, all engine synchronize
to the same rpm. Note that the trackpad Sync light will
show "yellow" if the control levers are not 10% of each
other. The light will show "green" when the engines syn-
chronize. The Sync light shows "gray" when Sync mode
is disengaged.
To engage Sync mode:
1. Press the Sync button.
To disengage Sync mode:
Place the ERC levers in any detent.
Press the Sync button.
Dock:
Dock mode decreases the percent of throttle throughout
the range by 50%. This is useful in docking where close
quarter maneuverability is required.
To engage the Dock mode:
1. Place both remote control levers in neutral.
2. Press the Dock trackpad button.
3. The Dock button light activates.
4. Place either remote control lever into gear.
5. The engines increase the rpm at a proportionally lower
rpm for the remote control position, and with 50% less
power than is normally available.
To disengage Dock mode:
1. Bring both remote control levers to forward, neutral or
reverse detent.
2. Press the Dock button. Dock mode deactivates and the
Dock button light goes out.
1 Lever:
This is a Zeus feature which in rough sea conditions per-
mits the operator to grasp a single control lever to com-
mand both engines simultaneously.
To engage the single lever mode:
1. Place both remote control levers in neutral.
2. Press the 1 Lever trackpad button.
3. The l Lever button light illuminates.
4. Place the port remote control into gear.
5. The engine rpm increases or decreases simultaneously
whil the Zeus drives remain in the same gear.
To disengage the 1 Lever mode:
1. Place both control levers in neutral.
2. Press the 1 Lever button; the 1 Lever button light turns
off.
Throttle Only:
To engage the Throttle Only mode:
1. Place both control levers in neutral.
2. Press the Throttle Only trackpad button.
3. The Throttle Only button light activates and the neu-
tral lights blink.
4. Place either remote control lever into gear.
5. The engine rpm can be increased while the Zeus drives
remain in neutral.
To disengage Throttle Only mode:
1. Return both remote control levers to neutral. Throttle
Only will not disengage unless the remote control levers
are in neutral.
2. Press the Throttle Only button and the light will deac-
tivate.
3. Note that the neutral light remains illuminated.
14
Chapter 5