Regal 53 SC Owner's Manual page 87

BATTERY MANAGEMENT SYSTEM-COMPONENT BREAKER DESCRIPTION
DASH MAIN- protects dash operation switch functions,
hardtop control panel, and engine hatch panel. In addi-
tion, it controls components located on the helm breaker
sub-panel located in the main stateroom electronics lock-
er. See the illustration for more information. Engine func-
tions are not controlled by the dash main breaker.
CABIN MAIN- protects the cabin main DC panel which
controls direct current switch functions.
ELECTRONICS- protects all electronic dash equip-
ment components along with the Fusion stereo compo-
nents. In addition, this breaker controls all breakers from
the electronic through the sirius weather on the helm
breaker panel located at the main stateroom electronics
locker. See the illustration for further information.
SALON WINDOW- protects motor circuitry.
ACCESSORY (ACC)- protects any add-on equipment
components. If adding components ensure that the am-
perage does not exceed the safe limits of the breaker.
TENDER WINCH- protects the power winch in the
dinghy garage (option).
AMPLIFIER- protects the stereo system amp.
UNDERWATER LTS- protects LED circuitry.
CHARGER- This breaker protect the 50 amp Mass
Combi battery charger circuitry.
SUNROOF- protects the sunroof motor.
CHARGER- This breaker protects the 50 amp cranking
battery charger circuitry.
WINDLASS- protects the deck mounted anchor wind-
lass circuitry. Notice this is a double pole breaker at 150
amps mainly because of the high current draw required
by the motor to retrieve the anchor and the length of the
windlass wire runs.
CABLE MASTER- protects the shore power hose reel.
OIL CHANGER- protects the engine and generator oil
changer pump circuitry located in the bilge.
HATCH LIFT- protects the aft engine hatch circuitry.
FWD. BILGE PUMP- protects the forward most bilge
pump.
MID BILGE PUMP- protects the middle bilge pump
circuitry.
AFT BILGE PUMP- protects the aft bilge pump lo-
cated in the engine room under the center diamond plate
fl oor section between the engines.
HIGH WATER ALARM- protects the bilge high wa-
ter alarm. This audible alarm sounds at the dash should
bilge water reaches a predetermined level. Normally this
would indicate large volumes of water are entering the
bilge since normal amounts would be drawn overboard
via the bilge pump system.
STEREO MEMORY- protects the stereo system mem-
ory circuit and the stereo unit itself.
SEA- protects the sea chest motor and circuitry.
SHOWER PUMP- protects the bilge located shower
pump.
FWD. SHOWER PUMP - protects the mid shower
sump pump (located under salon fl oor) circuitry. Also,
this shower sump box is used to capture and evacuate the
forward and aft air conditioning condensation pan water.
Note that selected equipment breakers are part of optional equip-
ment not installed on your vessel. Also, due to panel vintage select
breakers may or may not be present on your battery management
panel.
35
Systems