Regal 53 SC Owner's Manual page 133

To use the on board potable water system with the hose
reel disconnect the dockside inlet hose and reinstall the
cap tightly. Retrieve the dockside water hose by using the
remote control or by pushing the retrieval switch until the
unit is fully retrieved. Read and understand the vendor
owner's manual before using the reels and the remote
control. There is a retrieval switch for each electric wash
down hose reel.
The electric wash down reel switches are controlled by the
cable master breaker on the battery management panel and
use 12 volt DC power for retrieval purposes.
Position the potable water tank valve to the "on" position.
At the 12 volt ship's main control panel fl ip the fresh water
pressure pump and booster pump breakers to the "on"
position which will activate both pumps.
Note: Open the potable water tank valve when the onboard water
tanks need to be fi lled.
Engine Room Wash Down Hose
SPIGOT
WASH
DOWN
HOSE
TYPICAL BILGE
and booster pump breakers are activated at the ship's main
control panel. Connect the female hose fi tting to the engine
room spigot and turn on the spigot.
WARNING
!
PREVENT INJURY AND PROPERTY DAMAGE
DUE TO FIRE OR ELECTRICAL SHOCK!
NEVER WASH DOWN ENGINE ROOM
ELECTRICAL COMPONENTS. WASH DOWN
HOSE IS FOR BILGE FLOOR
SURFACE USE ONLY.
WARNING
!
PREVENT PROPERTY DAMAGE!
DEACTIVATE THE FRESH WATER
PRESSURE PUMP AND BOOSTER PUMP
BEFORE LEAVING THE VESSEL.
81
Systems
T h e c o i l e d
h o s e i n t h e
engine room
is for cleaning
the bilge fl oor
surface only. To
use the feature
with the ship's
potable fresh
ELECTRIC
water system
CORD
make sure the
REEL
pressure water
BREAKER