Table of Contents
Advertisement
STEP 6 - Selecting a Source
Press one of the input keys on the remote or built-in keypad to select and display the image for the source you
connected in Step 3.
STEP 7- Adjusting Image
Adjust the image settings, such as Brightness, Contrast, Gamma, Focus, Zoom etc. using the direct keys on the
remote or built in keypad.
2.2
Detailed Setup and Installation
DANGER
WARNING
2.2.1 Mounting
There are several methods for mounting the projector. In typical front and rear screen installations the projector
can be mounted to a secure and level surface, such as a table or cart. Carts are useful when the projector has to
be moved often. Lock the wheels on a cart, when it is in position, to prevent accidental movement during a
presentation.
Ceiling Mount
The projector can be inverted and suspended from the ceiling using a specially designed ceiling mount 104-
100001-XX. This mounting is recommended for those that want the projector out of plain view or have limited
amount of space for the projector. For more information, contact your dealer.
WARNING
2.2.2 Basic Optical Alignment
Only perform image alignment once the projector is fully assembled and powered up in its final location. Basic
image alignment ensures the image reflected from the DMDs is parallel to and well-centered with the lens and
screen. This initial optical alignment is the foundation for optimizing images on the screen and must be
completed before final boresight adjustments. Before beginning ensure the projector is properly positioned
relative to the screen.
Basic Optical Alignment Procedure
1. Display a test pattern: Appropriate for analyzing image focus and geometry, such as the "framing" test
pattern showing the cross-hair centered across the image. Press the T
the built-in keypad and press the soft key that displays Test on the LCD display.
2. Course focus: Do a quick preliminary focus and (if available) zoom adjustment with the primary lens. Do
not worry about consistency across the image at this point, just center focus. It is good practice to have
zoom adjustment color and focus adjustment color in the center of its range.
3. Center the image in the lens: Holding a piece of paper at the lens surface, adjust offsets as necessary until
the image is centered within the lens perimeter. A full white field works best for this.
J Series 1000W & 1200W Setup Guide
020-100740-02 Rev. 1 (03-2014)
NOTE:
Refer to
Always power down the projector and disconnect all power sources before servicing
or cleaning.
Refer to Safety Warnings and Guidelines in
Use only the Christie approved ceiling mount kit designed for your projector. Refer to
the installation instructions and safety guidelines provided in the kit.
Section 3 Operation
for more details.
Section 4 Maintenance
Section 2: Installation and Setup
.
EST
key on the remote keypad or use
2-5
Advertisement
Table of Contents
