Connect The Line Cord; Power Up; Select A Source; Adjust The Image - Christie M Series User Manual

Section 2: Installation and Setup

2.1.4 Connect the Line Cord

IMPORTANT!Use the line cord provided with the projector, or ensure you are using a line cord, power plug
Connect the projector line cord to the AC receptacle at the AC inlet of the projector, then push the wire clip
over the plug to retain it. This prevents the line cord from inadvertent disconnection. Plug the 3-pronged plug
end into a suitably rated grounded AC receptacle. Switch the projector ON. The switch is located just above the
AC receptacle.
NOTE: This product can be connected to an IT power distribution system.

2.1.5 Power up

After the AC Power has been switched on, the LCD display above the keypad indicates "Please wait" and the 4
LED status indicators on the top cover window switch on to amber. These indicate that the projector is
changing its state from powered down to standby. The message "Standby Mode" appears in the display when
the projector has completed its initialization and is ready for power up. The 2 lamp status LEDs will go off to
indicate that the lamps are off. The Power status LED will show amber, indicating that the projector is in
standby mode. The shutter LED will display amber, indicating the shutter is closed. Press and hold the power
button on the keypad or remote for 2 seconds, or press twice quickly. The lamps will power on and the fans will
come on. See Section 3 Operation
NOTE: The default settings for the projector are to perform a lens calibration after the insertion of a new lens.
If this is the first time the projector has been powered up with the lens, expect a short period (about 15 seconds)
where the lens will move slightly.

2.1.6 Select a Source

Press one of the input keys on the remote, or on the built-in keypad to select and display the image for the
connected source.

2.1.7 Adjust the Image

Adjust the image settings, such as Brightness, Contrast, Gamma, Focus, Zoom etc. using the direct keys on the
remote, or on the built-in keypad. See
2.2

Detailed Setup and Installation

2-4
and socket that meet the appropriate rating standards. Voltage and current requirements are
listed on the license label, located at the back of the projector.
Do not attempt operation if the AC supply and cord is not within the specified
ratings. On power down, wait 5-10 minutes for the fans to turn OFF before
unplugging the projector. Always switch off the projector before unplugging
the AC line cord.
for a full description of the status indicators.
Section 3 Operation
Always power down the projector and disconnect all power sources before
servicing or cleaning.
See the Safety Warnings and Guidelines in
for more details.
1.4 Safety Warnings and Guidelines.
M Series User Manual
020-100009-08 Rev. 1 (05-2013)