Power Up; Select A Source; Adjust The Image; Detailed Setup And Installation - Christie M Series Setup Manual

Section 2: Installation and Setup

2.1.5 Power up

After the AC Power has been switched on, the LCD display above the keypad indicates "Please wait" and the 4
LED status indicators on the top cover window switch on to amber. These indicate that the projector is
changing its state from powered down to standby. The message "Standby Mode" appears in the display when
the projector has completed its initialization and is ready for power up. The 2 lamp status LEDs will go off to
indicate that the lamps are off. The Power status LED will show amber, indicating that the projector is in
standby mode. The shutter LED will display amber, indicating the shutter is closed. Press and hold the power
button on the keypad or remote for 2 seconds, or press twice quickly. The lamps will power on and the fans will
come on. See Section 3 Operation
NOTE: The default settings for the projector are to perform a lens calibration after the insertion of a new lens.
If this is the first time the projector has been powered up with the lens, expect a short period (about 15 seconds)
where the lens will move slightly.

2.1.6 Select a Source

Press one of the input keys on the remote, or on the built-in keypad to select and display the image for the
connected source.

2.1.7 Adjust the Image

Adjust the image settings, such as Brightness, Contrast, Gamma, Focus, Zoom etc. using the direct keys on the
remote, or on the built-in keypad. See
2.2

Detailed Setup and Installation

2.2.1 Mounting

There are several methods for mounting the projector. In typical front and rear screen installations the projector
can be mounted to a secure and level surface, such as a table or cart. Carts are useful when the projector has to
be moved often. To prevent accidental movement during a presentation, lock the wheels on the cart.
Ceiling Mount
The projector can be inverted and suspended from the ceiling using a specially designed ceiling mount fixture
118-100108-XX. This mounting is recommended for those that want the projector out of plain view or have
limited amount of space for the projector. For more information, contact your dealer.
Special Mounting
The projector can also be rotated (front-to-back) up to 360 degrees and fixed in a rotated position without
affecting performance. However, the side-to-side tilt limit of the projector must not exceed +/-15 degrees, to
ensure optimal performance of the projector.
2-4
for a full description of the status indicators.
Section 3 Operation
Always power down the projector and disconnect all power sources before
servicing or cleaning.
See the Safety Warnings and Guidelines in
when the door is opened. The lamp doors are provided with clear windows to
indicate when the lamps are on.
Use only the Christie approved ceiling mount kit designed for your projector.
for more details.
4 Maintenance. Switch the lamp off
M Series Setup Guide
020-100011-05 Rev. 1 (07-2012)