5. Transport Belt Replacement
1. Remove the transport unit from the copier. (Refer to "Transport Unit
Removal".)
2. Remove the transfer and separation corona unit [A] (1 connector).
3. Remove the transport belt
tor).
4. Unhook the transport belt
transport belts [D].
NOTE: - When reassembling the transport belt unit, check that the transport
drive gear arm [E] is above the pin [F] as shown.
- Be sure to install the belts with the rough side out.
unit [B] (2 screws, 1 spring, and 1 connec-
roller [C] from the unit and replace the
5-33
30 April, '89