Transport Belt Replacement - Ricoh FT5034C Service Manual

7.2 TRANSPORT BELT REPLACEMENT

Original Table
Transport Belt
Drive Roller
Transport Belt
Front Transport Bracket
1. Remove the original table from the ADF by sliding it to the right.
2. Turn off the main switch and remove the ADF from the copier.
3. Place the ADF on a table with the transport belt side up.
4. Remove the feed-in cover (3 screws), the handle cover (4 screws), and the
feed-out cover (2 screws).
5. Remove the transport gear and the bearing from the front side (1 E-ring).
6. Slide the other bearing on the transport belt drive roller shaft to the rear (1 E-ring).
7. Free the transport belt drive roller from the ADF frame.
8. Remove the front transport bracket from the ADF main cover (2 screws).
9. For all the belt support rollers, press down the belt support roller shaft to slide out
the front end from the holder hook.
10. Take out the transport belt from the rollers.
11. Install a new transport belt and reassemble the ADF.
NOTE: Make sure that all the plastic bushings for the belt support roller shaft
are properly positioned in the holder hooks (8 bushings for the front and
rear).
Feed-out Cover
Holder Hook
- 14 -
Bearing
Bearing
Transport Gear
Belt Support Roller
Plastic Bushing
Feed-in Cover
Handle Cover