Transmission Oil - HYOSUNG MS3 250 Sercie Manual

TRANSMISSION OIL

Inspect Interval
Inspect Initial 1,000 km and Every 8,000 km there-
after.
▣ ▣ TRANSMISSION OIL REPLACEMENT
After a long period of use, the transmission oil quali-
ties will deteriorate and quicken the wear of sliding
and interlocking surfaces. Replace the transmission
oil periodically following the procedure below.
● Keep the motorcycle upright with the center stand.
● Start the engine to warm up the oil, this will facili-
tate draining oil.
● Place a drain pan under the engine.
● Remove the transmission oil filler cap ① .
● Release and remove the transmission oil level bolt
② and oil drain bolt ③ .
● Let all transmission oil drain out.
Collect it in a drian pan with adequate capacity.
● Fit and tighten the transmission oil drain bolt ③
the specified torque.
Transmission oil drain bolt
● Fill about 400 ㎖
of the specified of through the
transmission oil filler hole.
TRANSMISSION OIL CAPACITY
CHANGE
OVERHAUL
● Install the transmission oil filler cap ① .
● Check the transmission oil level using the trans-
mission oil level bolt hole and top up as required
without exceeding the transmission oil level bolt
hole.
● Tighten the transmission oil level bolt ②
specified torque.
Transmission oil level bolt
● Operate the engine a few minutes by idling speed.
Inspect the oil leakage at the transmission oil drian
bolt and oil level bolt.
: 12 N∙ ∙ m (1.2 kgf∙ ∙ m)
400 ㎖
410 ㎖
to the
: 12 N∙ ∙ m (1.2 kgf∙ ∙ m)
to
②
③
PERIODIC MAINTENANCE 2-14
①