HYOSUNG MS3 250 Sercie Manual page 94

3-51 ENGINE
◉ ◉ CLUTCH SHOE / MOVABLE
DRIVEN FACE ASSEMBLY
● Insert the drive belt between the driven faces as
deep inside as possible while pulling the movable
driven face all the way outside to provide the max-
imum belt clearance.
CAUTION
� � Position the drive belt so that the arrow � �
points the engine rotating direction.
� � Degrease the drive belt contact surface (pulley
face).
● Install the clutch shoe / movable driven face
assembly ① .
CAUTION
Pull the center area of upper and lower belt lines
to be close to each other to prevent the belt from
expanding.
● Tighten the clutch housing nut ②
torque.
CAUTION
Degrease the inner surface of the clutch housing.
Clutch housing nut
◉ ◉ MOVABLE DRIVE FACE
ASSEMBLY
● Check that no roller inside the movable drive face
is out of position from the slot.
● Install the movable drive face assembly ③ .
CAUTION
� � The assembly work should be carefully per-
formed so as not to allow the roller to dislocate.
� � Degrease the drive belt contact surface (pulley
face).
to the specified
: 60 N∙ ∙ m (6.0 kgf∙ ∙ m)
�
②
①
③