HYOSUNG MS3 250 Sercie Manual page 198

8-19 CHASSIS
● Apply SILICONE GREASE to the brake caliper
holder.
SILICONE GREASE
● Install the brake pads. (Refer to page 2-19)
● Tighten the caliper mounting bolts ① .
● With the hose end seated to the stopper, tighten
the right and left front brake hose union bolt ② .
Front brake caliper mounting bolts
: 18 ~ 28 N∙ ∙ m (1.8 ~ 2.8 kgf∙ ∙ m)
Front brake hose union bolts
: 20 ~ 25 N∙ ∙ m (2.0 ~ 2.5 kgf∙ ∙ m)
● Fill the system with brake fluid and bleed air.
(Refer to page 2-20)
Inspection after reassembly : Refer to page 2-18
◉ ◉ BRAKE DISK INSPECTION
Check the brake disk for damage or cracks. Measure
the thickness using the micrometer.
Replace the brake disk if the thickness is less than
the service limit or if damage is found.
Brake disk thickness
Micrometer (0� � 25 mm) : 09900-20201
Service limit
3.0 mm (0.12 in)
①
[Left front brake]
②
[Right front brake]
②
①