Caliper Inspection; Caliper Reassembly - HYOSUNG MS3 250 Sercie Manual

● Remove the dust seal ①
NOTE
� � Care not to cause scratch on the cylinder bore.
� � Do not reuse the piston seal and dust seal that
have been removed.
◉ ◉ CALIPER INSPECTION
Inspect the caliper cylinder wall and piston surface
for scratch, corrosion or other damages.
If any abnormal condition is noted, replace the
caliper.
◉ ◉ CALIPER REASSEMBLY
Reassemble the caliper in the reverse order of disas-
sembly procedures and observe the following points.
NOTE
� � Wash the caliper components with fresh brake
fluid before reassembly. Do not wipe off brake
fluid after washing the components.
� � Replace the piston seal and dust seal into new
ones with brake fluid applied.
Brake fluid specification and classification
● Install the brake pad spring.
and piston seal ② .
: DOT 4
①
②
CHASSIS 8-18