Tire; Chassis Bolts And Nuts - HYOSUNG MS3 250 Sercie Manual

2-23 PERIODIC MAINTENANCE

TIRE

Inspect Interval
Inspect Initial 1,000 km and Every 4,000 km thereafter.
▣ ▣ TIRE TREAD CONDITION
Operating the motorcycle with excessively worn tires
will decrease riding stability and can lead to loss of
control.
● Inspect shortage of tire thread's depth by the �tire
wear indicator� .
● Replace the front and rear tires at once when
appear the �tire wear indicator� .
▣ ▣ TIRE PRESSURE
If the tire pressure is too high or too low, steering will
be adversely affected and tire wear increased.
Therefore, maintain the correct tire pressure for good
enter key roadability or shorter tire life will result.
Cold inflation tire pressure is as follows.
SOLO RIDING
COLD INFLATION
TIRE PRESSURE
kPa
Front 172
Rear 197

CHASSIS BOLTS AND NUTS

Inspect Interval
Inspect Initial 1,000 km and Every 4,000 km thereafter.
Check that all chassis bolts and nuts are tightened to
their specified torque. (Refer to page 9-17)
DUAL RIDING
2 2
kgf/cm psi kPa kgf/cm
1.75 25.0 172 1.75
2.00 29.0 246 2.50
The standard tire on
120/70-13M/C 53S for front and
140/60-14M/C 64S for rear.
The use of tires other than those specified may
cause instability. It is highly recommended to use
a HYOSUNG Genuine Tire.
psi
25.0
36.0
Tire wear indicator
Tire wear indicator mark
CAUTION
are