Ignition System - HYOSUNG MS3 250 Sercie Manual

7-3 ELECTRICAL SYSTEM

IGNITION SYSTEM

◉ ◉ IGNITION SYSTEM INSPEC-
TION
▣ ▣ IGNITION COIL PRIMARY PEAK VOLT-
AGE INSPECTION
● Lift and support the side cover with the side cover
stay. (Refer to page 2-2)
● Disconnect spark plug cap.
● With the spark plug cap connected, place a new
spark plug on the engine to ground it.
NOTE
� � Check that all the couplers are connected.
� � Check that the all battery is fully charged.
Measure the ignition coil primary peak voltage using
the tester in the following procedure.
● Connect the tester as follows.
�
Probe : WL lead wire terminal
� Probe : Ground
NOTE
Do not disconnect the ignition coil / plug cap lead
wire couplers.
Pocket tester : 09900-25002
G
L
IG. S/W
Y
Y REG
REC
Y
FUSE
BATTERY
12V 8Ah