Sensors - HYOSUNG MS3 250 Sercie Manual

SENSORS

◉ ◉ PICK-UP COIL INSPECTION
The pick-up coil ① is installed in the magneto cover.
(Refer to page 7-6)
◉ ◉ PICK-UP COIL REMOVAL AND
INSTALLATION
● Remove the magneto cover. (Refer to page 3-7)
● Install the magneto cover in the reverse order of
removal.
◉ ◉ IAP SENSOR INSPECTION
The intake air pressure (IAP) sensor ②
the upside of the intake pipe. (Refer to page 4-22)
◉ ◉ IAP SENSOR REMOVAL AND
INSTALLATION
● Lift and support the side cover with the side cover
stay. (Refer to page 2-2)
● Remove the IAP sensor from the intake pipe.
● Install the IAP sensor in the reverse order of
removal.
◉ ◉ TP SENSOR INSPECTION
The throttle position (TP) sensor ③
left side of the throttle body. (Refer to page 4-17)
◉ ◉ TP SENSOR REMOVAL AND
INSTALLATION
CAUTION
Never remove the TP sensor.
◉ ◉ WT SENSOR INSPECTION
The water temperature (WT) sensor ④
the rear side of the thermostat case. (Refer to page
4-20)
◉ ◉ WT SENSOR REMOVAL AND
INSTALLATION
● Remove the WT sensor. (Refer to page 6-8)
● Install the WT sensor in the reverse order of
removal.
WT sensor : 18 N∙ ∙ m (1.8 kgf∙ ∙ m)
is installed at
is installed at the
is installed at
FI SYSTEM DIAGNOSIS 4-34
①
③
④
②