HYOSUNG MS3 250 Sercie Manual page 203

● Remove the handlebar by removing the handlebar
set bolt ① .
◉ ◉
REASSEMBLY
Reassemble the handlebars in the reverse order of
removal.
Pay attention to the following points :
● Tighten the handlebar set bolt ①
torque.
Handlebar set bolt
: 40 ~ 50 N∙ ∙ m (4.0 ~ 5.0 kgf∙ ∙ m)
● With the stopper ②
hole ③ , assemble the handle switch.
● When remounting the brake master cylinder onto
the handlebars, align the brake master cylinder
holder's mating surface with punch mark ④
handlebars.
● Tighten the master cylinder upper bolt first tem-
porarily to provide clearance on the master cylin-
der lower side and then tighten both the bolts to
the specification.
Master cylinder mounting bolt :
: 8 ~ 12 N∙ ∙ m (0.8 ~ 1.2 kgf∙ ∙ m)
Perform the following inspections after assembly has
been completed.
* Brake ∙∙∙∙∙∙∙∙∙∙∙Refer to page 2-18
* Throttle operation and cable play
∙∙∙∙∙∙∙∙∙∙∙∙∙∙Refer to page 2-11
to the specified
engaged with the handlebar
①
①
on the
②
③
CHASSIS 8-24
④
③
②
④