HYOSUNG MS3 250 Sercie Manual page 83

◉ ◉ CRANK BALANCER GEAR
● When installing the crank balancer driven No.1
gear ① , align the pawl � of the crank balancer
with the recess � of the crank balancer driven
No.1 gear ① . (Only for
● When installing the crank balancer drive gear ② ,
align the pawl � of the crankshaft with the recess
� of the crank balancer drive gear ② .
(Only for
CAUTION
Make sure that the punch mark � � on the balancer
drive gear is aligned with the punch mark � � on
the balancer driven No.1 gear.
(Only for
● Hold the crankshaft immovable using the special
tool.
Conrod holder : 09910-20115
● Using the special tool, tighten the balancer drive
gear nut ③ to the specified torque.
Crank balancer socket wrench
Crank balancer drive gear nut
: 100 ~ 120 N∙ ∙ m (10.0 ~ 12.0 kgf∙ ∙ m)
)
)
)
: 09940HP7600
① �
�
ENGINE 3-40
②
�
�
�
�
③