HYOSUNG MS3 250 Sercie Manual page 76

3-33 ENGINE
▣ ▣ CLUTCH SHOE INSPECTION
Inspect the linings for crack, uneven wear or burning.
Measure the lining thickness with a vernier calipers.
If any defects are found or measurement exceeds
the limit, replace the clutch shoe assembly with a
new one.
Clutch shoe
thickness
Vernier caliper : 09900-20101
▣ ▣ CLUTCH HOUSING INSPECTION
Inspect the inner surface of clutch housing for deep
scratches or discoloration caused by burning.
Measure the clutch housing inside diameter with an
inside calipers.
If any defects are found or measurememt exceeds
the limit, replace the clutch housing with a new one.
Clutch housing I.D.
Clutch housing I.D.
▣ ▣ MOVABLE DRIVEN FACE SPRING
INSPECTION
Measure the free length of movable driven face
spring. If length is shorter than the service limit,
replace the spring with a new one.
Movable driven face
spring free length
Movable driven face
spring free length
Vernier caliper : 09900-20101
Service limit
1.0 mm (0.04 in)
Service limit
134.5 mm (5.295 in)
Service limit
125.5 mm (4.941 in)
Service limit
124.0 mm (4.88 in)
Service limit
70.0 mm (2.76 in)