Summary Of Programming Commands - ADEMCO Via 30+ Installation Instructions Manual

Summary of
Programming
Commands
ENTER PROGRAMMING MODE | 1. POWER UP, then depress
[*] and [#] both at once, within
50sec of powering up.
2. Initially, key: 4+1+1+1
plus CODE key + 0.
OR
13. If different Master Code is programmed,
key :
MASTER CODE + CODE KEY + 0.
(if *98 was used to exit previously,
method 1 above must be used to enter
INITIALIZE DOWNLOAD ID
AND
SUBSCRIBER ACCT NUMBER
FOR DOWNLOADING
TO DEFAULT VALUES
EXIT PROGRAMMING MODE | * 98 Inhibits re-entry to programming
mode via type 2 or 3 entry method
above.
*99 Allows re-entry to programming
mode via type 2 or 3 entry method.
[¥] + Field No. (e.g., 21, 38, 56, etc.)
[*] + Field No., followed by data entries.
Some fields require sequential pressings of
*] to enter data (e.g., fields 56, 80, 81).
[*] + Field No. + [*] (only applies to
fields 40 thru 43 and 94).
READ FIELD [#] + Field No. Data will either be
automatically sequentially displayed or can
be displayed by successivel i n g [#].
*96 No data entry required,
loads defaults.
-~17-