System Operation - ADEMCO LYNXR Installation Manual

Hide thumbs Also See for LYNXR:
Table of Contents

Advertisement

System Operation

Security Codes
Installer Code
The installer programs the 4-digit Installer Code initially as part of the programming procedure. The factory default Installer
Code is 4-1-1-2, but may be changed in field
The Installer Code is the only code that can enter Programming mode and also, in normal operation mode, is used to enter the
Master Code, which allows access to the normal functions of the system.
Master Code
In normal operation mode, the Installer Code is used to enter the 4-digit Master Security Code using the keypad:
To enter/change the Master code by installer, enter:
To change the Master code by master, enter:
Secondary User Codes
In normal operation mode, the Master Security Code can be used to assign up to 6 secondary 4-digit security codes,
including a Babysitter Code and a Duress Code. The Master Code can also be used to remove secondary codes from the
system (individually).
To assign (or change) a secondary security code, enter:
The system will emit a single beep when each secondary code has been successfully entered.
To delete a secondary security code, enter:
Notes:
All Master and Secondary security codes permit access to the system for arming, disarming, etc.
• The Installer Code can disarm the system only if it was used to arm it. In addition, the Installer Code cannot disarm the
system if it was armed by pressing and holding a Quick-Arm button.
• Babysitter Code is User Code No. 7; i.e., it can disarm the system only if it was used to arm it. In addition, the Babysitter
Code cannot disarm the system if it was armed by pressing and holding a Quick-Arm button.
• Duress code is User Code No. 8. When this is used to perform any system operation, a special code is sent to the
monitoring station. Instruct users to be careful not to use this code for normal usage.
• If a secondary code is inadvertently repeated for different users, the lower user number will take priority.
• Opening and closing reports are sent for the Installer Code as No. 01, with the appropriate subscriber number. Master
Code and set of secondary user codes are sent as Nos. 02 and 03–08, respectively, in Contact ID format (with the
appropriate user number); in 4+2, it is 1–8. Quick arming is reported as user 00.
Panic Keys
There are three panic key pairs that, if programmed, can be used to manually initiate alarms and send a report to the central
station.
Each can be individually programmed for 24-hour silent, audible, personal or fire emergency responses. The panic function is
activated when both keys of the appropriate key pair are pressed at the same time.
The panic functions are identified by the system as follows:
Keys
Displayed as Zone
[1] & [
]
*
[
] & [#]
*
[3] & [#]
Installer Code + [CODE key] + [02] + desired 4-digit Master Code
Current Master Code + [CODE key] + [02] + new Master Code + new Master Code again
Master Code + [CODE key] + User # (03–08) + desired Secondary Code
Master Code + [CODE key] + User # (03–08)
Important: For the silent panic
95
functions to be of practical value,
the system must be connected to a
99
central station.
96
*
20.
–36–

Hide quick links:

Advertisement

Table of Contents
loading

This manual is also suitable for:

Lynxr24

Table of Contents