Scene Mode - Lutron Electronics QSGRJ-3P Installation And Operation Manual

Occupancy Sensor Setup (continued)

Scene Mode

This step allows you to assign up to 16* occupancy sensors to the GRAFIK Eye
control unit.
Selecting Sensors
Occ Sensor
1. If not already done, associate occupancy sensors and set to
Setup
"Scene Mode."
2. Use the Master buttons to highlight "Setup" and press the
Labels
"OK" button to accept. The info screen will display "Searching"
while the unit detects available occupancy sensors.
3. Use the Master buttons to scroll through the list of available
occupancy sensors. When the desired sensor is displayed,
Saved
Searching
press the "OK" button to select it. Then choose "Assign" or
"Unassign" from the following menu and press OK. Once a
sensor has been assigned, it will appear with an asterisk (*)
in the sensor list. Repeat for additional sensors.
Sensor x/y
Note: If wireless sensors are not found, verify that they are
xxxxxxxx
Setting the Sensor Action
yyyy-yyyy
RF
1. Press the Timeclock (back) button to return to the Occ Sensor
screen. Use the Master buttons to highlight "Actions" and press
the "OK" button. By default, the occupied scene is set to "No
Assignment
Action" and the unoccupied scene is set to "Scene Off."
2. Use the Master buttons to highlight the scene you wish to
Assign
use for occupied status and press the "OK" button to accept.
Unassign
Repeat for the scene you wish to use for unoccupied status.
Press the "OK" button to accept.
3. Exit programming mode.
Saved *Assigned*
Occ Sensor
Sensor *x/y
xxxxxxxx
Actions
yyyy-yyyy
3 seconds
Setup
RF
* Applicable only to units that ship with firmware version 9.003 and higher. Previous versions support up to 4 sensors.
®
associated correctly.
Occupied Scene
Scene 1
QS
®
Unoccupied Scene
Saved
Scene Off
GRAFIK Eye QS Control Unit Installation and Operation Guide 28
®
OK
Saved
Master
buttons
"OK"
button
Timeclock
(back) button