Base Cards - Avaya IP Office Essential Edition Installation Manual

1.5 Base Cards

IP500 Digital Station Base Card
IP500 Analog Phone Base Card
IP500 ATM Combination Card
PARTNER Version Installation Manual
IP Office Essential Edition
The control unit has 4 slots for the insertion of base cards. The slots are
numbered 1 to 4 from left to right. Normally they can be used in any order,
however if the capacity for a particular type of card is exceeded, the card in
the rightmost slot will be disabled.
Each base card includes an integral front panel with ports for cable
connections. Typically the first 8 ports on the left are for connection of
extension devices. The 4 ports on the left are used for connection of trunks
if a trunk daughter card is added to the base card.
This card provides 8 DS (digital station) ports for the connection of
Avaya digital phones other than IP phones.
· The card can be fitted with an IP500 trunk daughter card which uses
the base card ports for trunk connection.
· Maximum: 3 per control unit.
· 4400 Series phones (4406D, 4412D and 4424D) are not supported
on this card. They are supported on an external expansion module.
The card is available in two variants, supporting either 2 or 8 analog
phone ports.
· The card can be fitted with an
the base card ports for trunk connection.
· Maximum: 4 per control unit.
· The analog phone ports do not include a ringing capacitor. Where this
is a requirement, connection should be via a Master socket containing
ringing capacitors.
· If fitted with an IP500 Analog Trunk daughter card, during power
failure phone port 8 is connected to analog trunk port 12.
This card provides 6 digital station ports (1-6), 2 analog extension ports
(7-8) and 4 analog trunk ports (9-12). The card also includes 10 VCM
channels.
· This card has a pre-installed
· Maximum: 2 combination cards per IP500 V2 control unit. Not
supported by IP500 control units.
· The analog phone ports do not include a ringing capacitor. Where this
is a requirement, connection should be via a Master socket containing
ringing capacitors.
· If fitted with an IP500 Analog Trunk daughter card, during power
failure phone port 8 is connected to analog trunk port 12.
System Overview: SD Cards
IP500 trunk daughter card
IP500 analog trunk daughter
- Issue 1c (09 April 2010)
which uses
card.
Page 13