Vertical SBX IP 320 Features & Operation Manual page 67

Call Handling
To register the mobile extension CLI number to a DKT:
1.
2.
3.
To use the mobile extension in case of Hunt group member:
1.
2.
3.
Incoming call through DID, ICM or Transferring call:
1.
2.
3.
4.
5.
Transferring a call from the mobile extension through the SBX IP 320 system:
1.
2.
3.
4.
5.
Press the [TRANS/PGM] + 35.
Dial the mobile CLI number.
Press the [HOLD] button.
Press the [TRANS/PGM] + 36.
Dial "1" to activate, or "0" to deactivate.
Press the [HOLD] button.
The call to the extension which has the preprogrammed mobile extension is routed to
both an extension and a mobile extension.
When an incoming call is answered at an extension or at a mobile extension, the other
will stop ringing.
If mobile is answered, the extension goes to Mobile-Ext In Used State [IN USE AT
MOBILE EXT].
Under the Mobile-Ext In Used State, the extension cannot receive any digits.
If another extension tries to call the extension of Mobile-Ext In Used State, a busy tone
sounds. Call Waiting is not supported in this case, but the user can leave a message wait
to the extension of Mobile-Ext In Used State.
Dial the transfer code (*) during the talk state in Mobile extension. The mobile extension
user hears the internal dial tone and the calling party hears the MOH.
Dial the extension number.
The call will be transferred after the mobile extension user goes on-hook state.
The mobile extension user can reconnect the call by pressing the code (#) in the case that
the extension does not answer.
Mobile Extension can transfer a call to another station's mobile extension.
SBX IP 320 Features & Operation Guide
57