Vertical SBX IP 320 Features & Operation Manual page 136

Internet Protocol (H.450)
AT SYSTEM B
PGM
324
Operation
To enable the networking feature:
To satisfy the UDP condition:
Note: The changed Station numbers must not conflict with the flexible numbering plan code
for each System.
If system A has a flexible numbering code 2 as its Pick-Up code, then Station numbers that start
with the digit 2, cannot be used.
The destination IP address is needed to route:
PGM 324 - FLEX 4 is used to set the IP address of the destination System's VOIB.
Configure the VOIP Networking between System A & B as listed:
At system A: Enter PGM 105 + [SPEED] + 100 + 199 + [HOLD]
At system B: Enter PGM 105 + [SPEED] + 200 + 299 + [HOLD]
BIN FLEX
1 System usage
00 2 Numbering plan code
3 Numbering plan CO group
4 VOIP Called Party Information 1/2/3/4
1 System usage
01 2 Numbering plan code
3 Numbering plan CO group
4 VOIP CPN Information 1/2/3/4 (note)
The PGM 320 - FLEX 1 must be set to ON at each System (if the networking lock-key is
not installed, this ADMIN program cannot be enabled).
Flexible Station Numbering Plan (PGM 105) must be programmed at each System. At
this ADMIN program, the Station number range of System A can be changed from 100 to
199 (100-199), and System B also can be changed from 200 to 299 (200-299).
SBX IP 320 Features & Operation Guide
ITEM
126
VALUE
NET (0)
2#**
00
0.0.0.0
NET (0)
1**
01
VOIB IP Address of
system A