Vertical SBX IP 320 Features & Operation Manual page 164

Outgoing Call Access
Operation
To store a number in a System Speed Dial from the System Attendant:
1.
2.
3.
4.
5.
6.
7.
8.
9.
To make a call using System Speed Dial from a DKTU:
1.
2.
3.
Press the [TRANS/PGM] button.
Press the [SPEED] button.
Dial the System Speed Dial bin.
If desired, press the CO Line or Group button.
Dial the desired phone number and include these special codes (up to 24 digits).
• [CALLBK] - Insert Pause
• key - If stored as the first digit, its function is Display Security. Otherwise, its
function is Pulse to DTMF Switchover.
• [DND/FOR] - If CO Dial Tone Detect (refer to Ref. A) is ON and it is stored as
the first or second digit, and the accessed CO Line is behind the PBX mode, its
function is Dial Tone Detect. Otherwise, its function is Pause.
• [FLASH] - Inserts a Flash into the speed number.
• If the accessed CO Line is analog, its function is Flash to PX (or PBX).
• If the accessed CO Line is ISDN line (refer to Ref. B) and it is stored as the first
digit, it makes the remaining digits sent with envelope information not in the
Calling Party Number IE but in keypad facility IE.
Press the [HOLD/SAVE] button.
If desired, enter the name (up to 12 characters) by dialing 2-digits for each character.
Press the [HOLD/SAVE] button.
To store continuously, repeat this procedure from Step 3.
Lift the Handset or press the [SPEAKER] button.
Press the [SPEED] button.
Dial the System Speed Dial bin.
SBX IP 320 Features & Operation Guide
154