Epson Stylus Pro 7700 Service Manual page 296

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
5. Secure the new AID Board Cover with the three screws.
C H E C K
P O I N T
6. Install the Spindle Cover R.
7. Install the Right Cover.
8. Install the Maintenance Tank R.
9. Install the IC Cover R and the IC Shaft Cover R.
10. Install the Control Panel.
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing or removing the AID Board.
<Adjustment Item>
1. Counter Clear (AID)
2. Cleaning PG Adjustment
3. AID Function Check
DISASSEMBLY & ASSEMBLY
AID Board Cover
(p215)
(p209)
(p208)
(p206)
(p203)
(see p351) and perform
Disassembly and Assembly Procedure
Disassembling procedure for the new type after design change
The old AID Board cannot be installed to a new main body. Make
C A U T I O N
sure to prepare the new AID Board before taking the following
procedure.
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R.
3. Remove the Maintenance Tank R.
4. Remove the Right Cover. (p209)
5. Remove the three screws that secure the AID Board Cover.
A) Silver, Phillips, Round Washer Head S-tite M3x6: three pieces
6. Remove the AID Board Cover.
- Top right -
AID Board Cover
Figure 4-149. Removing the AID Board Cover
Revision I
(p206)
(p208)
Confidential
A
296