Epson Stylus Pro 7700 Service Manual page 293

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
11. Disconnect the FFC (CN400) from the Ink Holder Board Assy and release the FFC
from the clamp.
12. Disconnect the connectors (CN408, CN409) from the Ink Holder Board Assy R.
13. Remove the five screws that secure the plate.
A) Silver, Phillips, Bind P-tite M3x10: five pieces
14. Remove the plate.
15. Remove the ten screws that secure the Ink Holder Board Assy R.
B) Silver, Phillips, Bind S-tite M3x6: two pieces
C) Silver, Phillips, Bind P-tite M3x10: eight pieces
16. Remove the Ink Holder Board Assy R.
Be careful not to damage the CSIC terminal when removing/
installing the Ink Holder Board Assy R.
- Back of Ink Holder Board -
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing the Ink Holder Board Assy R.
<Adjustment Item>
1. Ink Holder Adjustment
DISASSEMBLY & ASSEMBLY
Terminal
(see p351) and perform
Disassembly and Assembly Procedure
CN400
Figure 4-145. Releasing the FFC
Plate
Ink Holder Board Assy R
Figure 4-146. Removing the Ink Holder Board Assy R
Revision I
Clamp
CN409
CN408
A
B
C
293
Confidential