Epson Stylus Pro 7700 Service Manual page 285

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
DISASSEMBLING PROCEDURE
1. Remove the IC Cover L and the IC Shaft Cover L.
2. Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Peel off the tape shown in the figure, and release the harness.
5. Pull off the Pressure Tube from the main body and release the Pressure Tube from
the guide.
6. Release the Ink Tubes from the two hooks on the Ink Cartridge Holder L.
7. Pull the Ink Tube backward to give it some slack.
Pull the Ink Tube forward to remove the slack. Route the Ink Tube
so as not to apply load to the bend of the tube at the front of the
printer.
8. Release the Ink Tubes from the six hooks on the Ink Tube Guide.
Be careful not to apply load to the joint of the Ink Cartridge Holder
C A U T I O N
L and the Ink Tube.
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
Disassembly and Assembly Procedure
Guide
Pressure Tube
Ink Tube Guide
Figure 4-134. Releasing the Waste Ink Tube and Pressure Tube (before released)
Figure 4-135. Releasing the Waste Ink Tube and Pressure Tube (after released)
Revision I
Tape
Ink Tubes
Hook
285
Confidential