Epson Stylus Pro 7700 Service Manual page 277

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.6.5 Ink Cartridge Holder R
This part is not compatible between Epson Stylus Pro 7900/
C A U T I O N
7910/9900/9910/7890/7908/9890/9908 and Epson Stylus Pro
7700/7710/7700M/7710M/9700/9710. If replaced with a new
part, see " 4.1.5 Differences of the parts/components between
(Page 172)
models "
correct one.
When disassembling this part, be sure to discharge ink in
advance following the procedure below.
INK DISCHARGE
1. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu
→ Maintenance→
2. Select SELF TESTING
3. Press the [OK] button.
4. Remove all the ink cartridges, and install the drain cartridges to all the ink slots.
5. Press the [OK] button to discharge ink.
6. Turn the printer OFF when [Press] Power Button
After discharging ink, the initial charge flag is automatically set.
C H E C K
P O I N T The next time turning the power on, the initial ink charge sequence
starts.
DISASSEMBLY & ASSEMBLY
in advance, then replace it with the
], [PaperFeed ], and [OK].
I/H Exchange→Sequence.
is displayed.
Disassembly and Assembly Procedure
Revision I
277
Confidential