Epson Stylus Pro 7700 Service Manual page 119

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
No. Message on LCD
44 NOZZLE CLOG DETECTED
NOT ENOUGH INK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
45 NOZZLE CLOG DETECTED
NOT ENOUGH EMPTY SPACE
IN MAINT TANK
CONTINUE CLEANING?
YES (RECOMMENDED)
NO
46 TAKE-UP DISCONNECTED
SET AUTO TAKE-UP REEL SYSTEM IN
PRINTER AND RESTART THE PRINTER
47 TAKE-UP DISCONNECTED
AUTO TAKE-UP REEL UNIT IS DISCONNECTED
DO YOU CONTINUE?
NO
YES
48 TAKE-UP ERROR
CHECK THE STATUS OF AUTO TAKE-UP REEL
UNIT AND RESTART THE PRINTER
49 TAKE-UP ERROR
IS ANYTHING OBSTRUCTING THE TAKE-UP
REEL SENSOR SYSTEM?
LOAD PAPER AGAIN
SProofer DISCONNECTED
50
CONNECT SpectroProofer TO THE PRINTER
AND RESTART THE PRINTER
ILS20EP DISCONNECTED
51
REFER TO THE MANUAL AND CONNECT
ILS20EP TO SpectroProofer
RESTART THE PRINTER
TROUBLE SHOOTING
Description
There is not enough ink to perform cleaning.
There is not enough space in the maintenance tank to
perform cleaning.
Auto Take-up Reel Unit is not correctly installed in the
printer. Auto Take-up Unit is disconnected when the printer
is turned on.
Auto Take-up Reel Unit is not recognized.
Auto Take-up Reel Unit is not correctly installed in the
printer. This occurs at power-on, the Auto Take-up Reel
Unit was connected the last time the printer was on.
Auto Take-up Reel Unit is not recognized.
The roll paper is not set to the Auto Take-up Reel Unit
properly.
The Auto Take-up Reel Unit does not wind the paper.
The SpectroProofer is not connected to the printer properly. Turn the printer off, and then connect the SpectroProofer to the printer
The color measurement device (ILS20EP) is not connected
properly.
Remedies for Error Messages
Remedy/Points to be checked
By clicking YES, the message to replace the ink cartridge appears.
Replace the ink cartridge with a new one to continue cleaning.
By clicking YES, the message to replace the maintenance tank appears.
Replace the maintenance tank with a new one to continue cleaning.
P.208)
Turn the printer off, and then install the Auto Take-up Reel Unit
properly.
Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit.
P.228, P.313)
Select NO, and turn the printer off, and then install the Auto Take-up
Reel Unit properly. If you select YES, the paper is ejected without
using the Auto Take-up Reel Unit.
Replace the USB cable.
Replace the Main Board Assy or the Auto Take-up Reel Unit.
P.228, P.313)
Press the button to release the paper presser, and then set the roll
paper to the Auto Take-up Reel Unit properly.
Check if there is some foreign material stuck on the sensor or the
reflector plate of the Auto Take-up Reel Unit, or some interruption of
the light by an obstacle.
properly.
Turn the printer off, and then connect the color measurement device
(ILS20EP) to the SpectroProofer properly.
Revision I
(See
(See
(See
119
Confidential