Epson Stylus Pro 7700 Service Manual page 249

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
14. Remove the each screw that secure the CR Stopper, and remove the three CR
Stoppers.
B) Silver, Phillips, Bind S-tite with S.W & P.W. M3x8: each one piece
15. Remove the Carriage Unit by sliding it rightward.
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing or removing the Carriage
Unit.
<Adjustment Item>
1. Nozzle Check
2. Ink Mark Sensor Adjustment
3. Skew Check
4. T&B&S Adjustment
5. Absorber Position Check
6. Printhead Slant Adjustment (CR)
7. Printhead Slant Adjustment (PF)
8. Head PG Adjustment
When replacing or maintaining the Carriage Unit, carry out the
Lubrication Lubrication
specified lubrication if necessary. (See Chapter 6 "
MAINTENANCE "
DISASSEMBLY & ASSEMBLY
(see p351) and perform
(Page 444)
.)
Disassembly and Assembly Procedure
CR Stopper
B
CR Stopper
B
Figure 4-80. Remove the CR Stopper
Carriage Unit
Figure 4-81. Remove the Carriage Unit
Revision I
CR Stopper
B
249
Confidential