Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.6.4 Pressurizing Unit
1.
Remove the Rear Cover.
(p220)
In the next step, confirm the destination of the Pressure Tubes so as
to restore the original routing when reassembling.
Epson Stylus Pro 7900/7910/9900/9910/WT7900/WT7910/7890/7908/9890/9908
Epson Stylus Pro 7700/7710/7700M/7710M/9700/9710
DISASSEMBLY & ASSEMBLY
2.
Disconnect the two Pressure Tubes from the Pressurizing Unit.
NOTE: In Epson Stylus Pro 7700/7710/7700M/7710M/9700/9710's case,
disconnect only the Pressure Tube shown in
3.
Remove the three screws that secure the Pressurizing Unit.
A) Silver, Phillips, Bind S-tite with S.W & P.W. M3x10: three pieces
Figure 4-123. Removing the screws securing the Pressurizing Unit
Disassembly and Assembly Procedure
Pressurizing Unit
Screw
together
Epson Stylus Pro 7700/7710/
C H E C K
P O I N T
7700M/7710M/9700/9710's case
Secure the Pressurizing Unit together with the grounding plate
using the same screw shown in the figure.
Revision I
Figure 4-123
.
Pressure Tube
A
275
Confidential