Epson Stylus Pro 7700 Service Manual page 248

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.4.9 Carriage Unit
1. Remove the Control Panel.(p203)
2. Remove the IC Cover (L/R) and the IC Shaft Cover
3. Remove the Maintenance Tank (L/R).(p208)
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
4. Remove the Right Cover.(p209)
5. Remove the Left Cover.(p211)
6. Remove the Top Cover.(p214)
7. Remove the Ink Selector.(p300)
8. Remove the Print Head.(p270)
9. Remove the Driven Pulley Unit.(p240)
10. Remove the APG Motor.(p243)
11. Remove the APG Unit.(p244)
12. Remove the CR Scale.(p236)
In the next step, after removing the Plate B the Main Frame will
C A U T I O N
drop and its weight may apply an extra load to the Carriage Unit.
Therefore, make sure to hold the cover or remove the Front Cover
(Middle) in advance.
will make the frame lighter and avoid extra loading to the Carriage
Unit.
13. Remove the nine screws that secure the Plate B, and remove the Plate B.
A) Silver, Phillips, Round Washer Head S-tite M3x6: nine pieces
DISASSEMBLY & ASSEMBLY
(L/R).(p206)
(p207) Removing the Front Cover (Middle)
Disassembly and Assembly Procedure
Figure 4-79. Removing the Plate B
Revision I
Plate B
A
248
Confidential