Epson Stylus Pro 7700 Service Manual page 337

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.8.11 Thermistor
1. Remove the Color Measurement Device.
2. Remove the Mounter. (p327)
3. Remove the Front Cover. (p331)
4. Remove the Right Cover. (p328)
5. Disconnect the connector (CN11) on the Main Board.
6. Remove the two screws that secure the USB Housing, and remove the USB
Housing.
A) Black, Phillips, Bind machine screw M3x6: two pieces
7. Release the harness of the Thermistor from the cable guide, and remove the
Thermistor.
Make sure to route the harness as shown in the figure.
DISASSEMBLY & ASSEMBLY
(p325)
Disassembly and Assembly Procedure
CN11
USB Housing
Figure 4-209. Removing the USB Housing
Thermistor
Routing
Cable guide
Figure 4-210. Removing the Thermistor
Revision I
A
337
Confidential