Epson Stylus Pro 7700 Service Manual page 269

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.6.2 Wiper Cleaner Assy
PREPARATION FOR REPLACEMENT
1. Remove the Control Panel. (p203)
2. Remove the IC Cover R and the IC Shaft Cover R.
3. Remove the Maintenance Tank R.
4. Remove the Right Cover. (p209)
5. Reinstall the Control Panel.
6. Turn the printer ON in the Serviceman Mode.
Turn the power ON while pressing [Menu
→
7. Select SELF TESTING Maintenance
8. Press the [OK] button.
The Carriage Unit moves, then the Wiper Cleaner Assy moves to the replacement
position.
9. Open the Front Cover.
DISASSEMBLING PROCEDURE
When working, follow the instructions below. Otherwise; this
C A U T I O N
procedure is carried out with the power on, the Carriage Unit may
operate.
Do not close the Front Cover.
Do not touch the parts other than described here.
Do not press any button on the Control Panel.
1. Push up the tab of the Wiper Cleaner Assy, and remove the Wiper Cleaner Assy.
Be sure to refer to Chapter 5 "Adjustment"
A D J U S T M E N T
R E Q U I R E D
specified adjustments after replacing the Wiper Cleaner Assy.
<Adjustment Item>
1. Counter Clear (Wiper)
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
], [PaperFeed ], and [OK] button.
→ →
Wiper Exchange Sequence.
(see p351) and perform
Disassembly and Assembly Procedure
AFTER REPLACEMENT
1. Press the [OK] button while [Enter] Finish
The Carriage Unit moves to the home position.
2. Turn the printer OFF.
3. Reinstall the removed parts.
Wiper Cleaner Assy
Figure 4-112. Removing the Wiper Cleaner Assy
Revision I
is displayed.
Tab
Confidential
269