Ink Holder Board Assy L - Epson Stylus Pro 7700 Service Manual

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908

4.4.6.7 Ink Holder Board Assy L

1. Remove the IC Cover L and the IC Shaft Cover L.
2. Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p211)
4. Pull off the Pressure Tube from the main body.
Make sure to connect the Pressure Tube.
5. Release the Pressure Tube from the guide of the Board Cover.
6. Pull out the Pressure Tube from the hole of the Board Cover.
7. Disengage the two hooks, and remove the Board Cover.
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
Disassembly and Assembly Procedure
Hole
Pressure Tube
Board Cover
Figure 4-142. Removing the Board Cover
Revision I
Hooks
Guide
290
Confidential