Epson Stylus Pro 7700 Service Manual page 253

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908
4.4.5.3 Driven Roller Release Motor
1. Remove the IC Cover L and the IC Shaft Cover L.
2. Remove the Maintenance Tank L.
NOTE: There is no Maintenance Tank (L) mounted for the Epson Stylus Pro
7700/7710/7700M/7710M/7900/7910/WT7900/WT7910/7890/7908.
3. Remove the Left Cover. (p209)
4. Remove the Rear Cover. (p220)
5. Disconnect the connector from the Driven Roller Release Motor.
6. Remove the two screws that secure the Driven Roller Release Motor, and remove
the Driven Roller Release Motor.
A) Silver, Phillips, Pan S-tite with S.W & P.W. M3x6: two pieces
DISASSEMBLY & ASSEMBLY
(p206)
(p208)
See Figure 4-82.
Disassembly and Assembly Procedure
- Rear left - Driven Roller Release Motor
Connector
Figure 4-87. Disconnecting the connector
- Left side -
Driven Roller Release Motor
A
Figure 4-88. Removing the Driven Roller Release Motor
Revision I
253
Confidential