Transportation - Epson Stylus Pro 7700 Service Manual

Epson Stylus Pro 7700/7710/7700M/7710M/7900/7910/9700/9710/9900/9910/WT7900/WT7910/9890/9908/7890/7908

6.3 Transportation

Make sure to keep the ink cartridge installed so as to prevent
C A U T I O N
ink from leaking or the printhead from drying.
Do not touch any parts other than those must be repaired to
avoid any damage to the printer.
PREPARATION FOR TRANSPORTATION
1. Turn off the printer, and remove all the cables such as the power cord after
confirming the printer is off.
2. Remove the roll paper, roll media adapter and the paper basket if attached to the
printer.
3. Remove the optional Auto Take-up Reel Unit or SpectroProofer Mounter if they
are installed.
4. Open the front cover and install the protective material for fixing the printhead,
and then close the cover.
MOVING/TRANSPORTING THE PRINTER
When you transport the printer, be sure to repack the printer using the original box and
packing materials.
When moving or transporting the printer, keep it flat. Do not
C A U T I O N
tilt it or turn it upside down to prevent ink from leaking.
When moving or transporting the printer on a bumpy surface,
make sure to lift the printer and carry it.
After moving the printer with the stand attached, tighten all the
screws securing the stand once again.
MAINTENANCE
SETTING UP THE PRINTER AFTER TRANSPORTATION
1. Make sure that the installation site is proper.
2. Connect the power cord, and turn the printer on.
3. Perform a nozzle check.
4. Perform the gap adjustment as explained on the user's guide.
Transportation
Revision I
449
Confidential