Console Port Connector Pinout Information For An Ex Series Switch; Table 33: Ex Series Switches Console Port Connector Pinout Information - Juniper EX6210 Complete Hardware Manual

Complete Hardware Guide for EX6210 Ethernet Switches
Related
Documentation

Console Port Connector Pinout Information for an EX Series Switch

Table 33: EX Series Switches Console Port Connector Pinout Information

Pin Signal
1 RTS Output
2 DTR Output
3 TxD Output
4 Signal Ground
5 Signal Ground
58
EX2200 Switches Hardware Overview
Rear Panel of an EX3200 Switch
Rear Panel of an EX3300 Switch
Rear Panel of an EX4200 Switch
EX4300 Switches Hardware Overview
Front Panel of an EX4500 Switch
EX4550 Switches Hardware Overview
Switch Fabric and Routing Engine (SRE) Module in an EX6200 Switch on page 26
Switch Fabric and Routing Engine (SRE) Module in an EX8208 Switch
Routing Engine (RE) Module in an EX8216 Switch
Routing Engine Module in an EX9200 Switch
Booting an EX Series Switch Using a Software Package Stored on a USB Flash Drive
The console port on an EX Series switch is an RS-232 serial interface that uses an RJ-45
connector to connect to a console management device. The default baud rate for the
console port is 9600 baud.
Table 33 on page 58 provides the pinout information for the RJ-45 console connector.
An RJ-45 cable and an RJ-45 to DB-9 serial port adapter are supplied with the switch.
NOTE: If your laptop or PC does not have a DB-9 male connector pin and you
want to connect your laptop or PC directly to an EX Series switch, use a
combination of the RJ-45 to DB-9 female adapter supplied with the switch
and a USB to DB-9 male adapter. You must provide the USB to DB-9 male
adapter.
Description
Request to send
Data terminal ready
Transmit data
Signal ground
Signal ground
Copyright © 2014, Juniper Networks, Inc.