Ln1000-V Rear Transition Module Front Panel Status Leds; Table 6: Ln1000-V Router Led Status - Juniper LN1000-V Hardware Manual

LN1000–V Rear Transition Module Front Panel Status LEDs

Table 6: LN1000-V Router LED Status

LED
PWR OK
LINK
ACT
Copyright © 2010, Juniper Networks, Inc.
To remove an SFP:
Place an electrostatic bag or antistatic mat on a flat, stable surface to receive the
1.
SFP. Have ready a rubber safety cap for the SFP transceiver and the cable.
Attach an electrostatic discharge (ESD) grounding strap to your bare wrist, and
2.
connect the strap to one of the ESD points on the chassis.
Label the cable connected to the SFP so that you can later reconnect it to the correct
3.
SFP.
Disconnect the cable from the SFP. Immediately cover the transceiver and the end
4.
of the cable with a rubber safety cap.
Arrange the cable to prevent it from dislodging or developing stress points. Secure
5.
the cable so that it is not supporting its own weight as it hangs to the floor. Place
excess cable out of the way in a neatly coiled loop. Placing fasteners on the loop
helps to maintain its shape.
Pull the ejector handle away from the SFP faceplate to unseat the SFP from the
6.
RTM. Pull the SFP out of the RTM and place it on the antistatic mat or in the
electrostatic bag.
CAUTION: After removing a transceiver from the chassis, wait at least 30 seconds
before reinserting it or inserting a transceiver into a different slot. Issue the
hardware detail command to verify the installed transceivers.
The LN1000-V rear transition module includes LEDs on the front panel to provide status
information.
Color
Off; No color
Steady Green
Off; No color
Steady Green
Off; No color
Blinking Green
Chapter 10: Installing the LN1000–V Rear Transition Module
Meaning
Power is off.
Ready for operation. The router is
powered on and has successfully run
POST diagnostics.
No link on associated port.
On: Link established.
No activity.
Traffic Activity
show chassis
33