Connecting And Configuring An Ex Series Switch (Cli Procedure) - Juniper EX4500 Hardware Manual

Connecting and Configuring an EX Series Switch (CLI Procedure)

Copyright © 2017, Juniper Networks, Inc.
There are two ways to connect and configure an EX Series switch: one method is through
the console by using the CLI and the other is by using the J-Web interface.
NOTE: EX2200-24T-4G-DC switches do not support switch connection and
configuration through the J-Web interface.
This topic describes the CLI procedure.
NOTE: To run the
configuration as the active configuration. If you have configured anything on
the switch and want to run
See Reverting to the Default Factory Configuration for the EX Series Switch.
Using the CLI, set the following parameter values in the console server or PC:
Baud rate—9600
Flow control—None
Data—8
Parity—None
Stop bits—1
DCD state—Disregard
Chapter 15: Performing Initial Configuration
ezsetup script, the switch must have the factory-default
, revert to the factory-default configuration.
ezsetup
159