Performing The Initial Software Configuration For The Ptx1000; Figure 35: Connecting The Ptx1000 Directly To A Management Console; Figure 36: Connecting The Ptx1000 To A Management Console Through A - Juniper PTX1000 Hardware Manual

PTX1000 Packet Transport Router Hardware Guide
Related
Documentation

Performing the Initial Software Configuration for the PTX1000

82

Figure 35: Connecting the PTX1000 Directly to a Management Console

Figure 36: Connecting the PTX1000 to a Management Console Through a Console Server
PTX1000 Management Panel on page 30
You must perform the initial configuration of the PTX1000 through the console port by
using the Junos OS command-line interface (CLI).
Before you begin connecting and configuring a PTX1000, set the following parameter
values on the management console or console server:
Baud Rate—9600
Flow Control—None
Data—8
Parity—None
Stop Bits—1
DCD State—Disregard
To connect and configure the PTX1000 from the console:
Connect the console port to a laptop or PC by using the supplied RJ-45 cable and
1.
RJ-45 to DB-9 adapter. The console port (labeled
panel of the PTX1000 (see
page 81 for more information).
Log in as root. There is no password. If the software boots before you connected to
2.
the console port, you might need to press the
login: root
Start the CLI.
3.
) is located on the management
CON
"Connecting the PTX1000 to a Management Console" on
Enter key for the prompt to appear.
Copyright © 2018, Juniper Networks, Inc.