Table of Contents
Advertisement
Output Bin Test - Standard Bin
This test verifies if the standard bin sensor is working correctly.
To run the Standard Bin Sensor Test:
1.
2.
3.
–
Manually actuate the bin sensor by moving the flag in and out of the sensor. The display
indicates OP (open) when the flag is out of the sensor and CL (closed) when the flag is in
the sensor.
4.
Output Bin Feed Test
Note: If the "Configure Bins" printer setting is link rather than mailbox, the printer selects
its own internal bin linking regardless of which output bin is selected for the feed test.
This test verifies that media can be fed to a specific output bin. No information is printed
on the media because the printhead is not turned on during this test.
To run the Output Bin Feed Test:
1.
2.
3.
4.
Output Bin Sensor Test
This test verifies if the any of the output bin sensors are working correctly.
The following Output options, if installed, are supported by this test.
To run the Output Bin Sensor Test:
1.
2.
–
5060-XXX
Select Output Bin Tests from the Diagnostic Menu.
Select Output Bin Tests - Sensor Tests.
Select Sensor Tests - Standard Bin.
"Standard Bin/Full=CL" message displays.
Press Return/Stop to exit the test.
Select Feed Test from the Output Bin Test menu.
Select the output bin you want the paper to exit into. All output bins installed on the
printer are shown on the feed test menu.
Select either Single (one sheet of media feeds to the selected output bin) or
Continuous (media continues feeding to the selected output bin) until Return/Stop is
pressed.
Press Return/Stop to exit the test.
Standard Bin
Output Expander
5-Bin Mailbox
Select Output Bin Sensor Test from the menu.
Select the Bin you want to test.
If Standard Bin is selected the following is displayed.
Standard Bin
3-15
Diagnostic Aids
Advertisement
Table of Contents
