Table of Contents
Advertisement
Print Tests
The Print Tests consist of the following tests:
Print Tests (input source)
This test determines if the printer can print on media from any of the paper input sources.
Each of the installed sources is available within the Print Tests menu.
The content of the test page will vary depending on the media installed in the selected
input source. If a source is selected that contains paper, then a page similar to the Quick
Test Page is printed and will not contain the Print Registration diamonds. If a source is
selected which contains envelopes then an Envelope Print Test pattern is printed. This
pattern only contains text, which consists of continuous prints of each character in the
selected symbol set. If continuous is selected, all sources printing with paper sizes will
print the same page continuously until the test is stopped. If continuous is selected from a
source which contains envelopes then the envelope print test pattern is printed on the
first envelope and the rest are blank. The Print Test page always prints single sided,
regardless of the Duplex setting or the presence of the Duplex unit.
To run the Print Test:
1.
2.
3.
Note: If Single is selected, no buttons are active while the Print Test Page is printing. If
Continuous is selected, Return or Stop can be pressed to cancel the test.
The following screen is displayed while printing.
<input source>=Tray 1,Tray 2, Tray 3, Tray 4, Tray 5, MP Feeder, or Env Feeder
<media width>=N for Narrow Width Media
=W for Wide Width Media
4.
5060-XXX
Tray 1
Tray 2 (if installed)
Tray 3 (if installed)
Tray 4 (if installed)
Tray 5 (if installed)
MP Feeder
Print Quality Pages
Print Line Len Pages
Select Print Test from the menu.
Select the paper source from the menu.
Select either Single or Continuous from the menu.
<input source>
Printing
<media width>
Press Return or Stop at the end of the test to return to the original screen.
3-21
Diagnostic Aids
Advertisement
Table of Contents
