Table of Contents
Advertisement
Error code
978 Standard Network
or
Network Card X
979 Standard Network
or
Network Card X
980 <device> comm
981 <device> comm
982 <device> comm
983 <device> comm
984 <device> comm
990 <device>
991 <device> Card
5060-XXX
Action
Bad checksum while programming network Network Card X port.
Flash parts failed while programming Network Card X port.
Engine is experiencing unreliable communications to the specified
device.
Errors 980 through 984 indicate the specified device has detected
a Paper Port communication failure.
Engine protocol violation detected by the specified device.
* Engine
* Duplex unit
* Tray x (where x=1,2,3,4, or 5)
Communications error detected by the specified device.
* Output Bin (where x=1,2,3,or 6)
Note: This message is used for single bin output devices.
* Bins x to y (where x to y= 1 to 5, 2 to 6, or 6 to 10)
Invalid command received by the specified device. Note: This
message is used for multiple bin output devices.
Note: Check the autoconnects above and below the failing option
to make sure they are seated and connected correctly. Go to the
service check for the device indicated.
Invalid command parameter received by the specified device.
This error message indicates that an equipment check condition
has occurred in the specified device, but the device is unable to
identify the exact component failure. Go to
displayed for Tray x" on page
Note: <device> can be one of the following:
* Duplex unit
* Tray x (where x=1,2,3,4, or 5)
* Output Bin x (where x=1,2,3, or 6)
Note: This message is used for single bin output devices.
* Output Bin x to y (where x=1 to 5, 2 to 6, or 6 to 20)
Note: This message is used for multiple bin output devices.
This error message indicates that a device has detected an
equipment check in its system board.
Note: <device> can be one of the following.
* Duplex unit
* Tray x (where x=1,2,3,4 or 5)
* Output Bin x (where x=1,2,3, or 6)
Note: This message is used for single bin output devices.
* Output Bin x to y (where x=1 to 5, 2 to 6, or 6 to 20)
Note: This message is used for multiple bin output devices. Go to
the service check for the device indicated.
"990 Error Code
2-115.
Diagnostic Information
2-9
Advertisement
Table of Contents
