Table of Contents
Advertisement
Once the maximum count is reached the test stops. The power indicator goes on solid
and the final results display.
Press Return/Stop to exit the test.
Input Tray Tests
Input Tray Feed Test
This test lets you observe the paper path as media is feeding through the printer. The
upper front door, used to access the print cartridge, cannot be opened during the feed
test. To observe the paper path, you must open the lower front door, used to access the
envelope feeder or MPF. No information is printed on the feed test pages since the laser
isn't engaged during this test.
Note: This test can be run using any of the paper or envelope sizes supported by the
printer. The pages are placed in the default output bin, however, the Feed Test menu lets
you to select the input source.
To run the Input Tray Feed Test:
1.
2.
3.
4.
Input Tray Sensor Test (500-Sheet Trays)
Use this test to determine if the input tray sensors are working correctly.
To run the Input Tray Sensor Test 500-Sheet Trays:
1.
–
–
5060-XXX
Data Error
Data 232 Error
Data 422 Error
FIFO Error
DSR Error
DSR PIO Error
DSR Interrupt Error
CTS Error
CTS PIO Error
CTS Interrupt Error
Select Input Tray Feed Test from the menu.
Select the input source from the sources displayed on the Feed Test Menu. All
installed sources are displayed.
Select either Single (feeds one sheet of media from the selected source) or
Continuous (continues to feed from the selected source until Return/Stop is
pressed).
Press Return/Stop to exit test.
Select the Sensor Test from the Input Tray Test menu.
Sensor L1=Input Tray level/empty Sensor 1
Sensor L2=Input Tray level/empty Sensor 2
3-13
Diagnostic Aids
Advertisement
Table of Contents
