Table of Contents
Advertisement
Step
Action and Questions
2
Check the Vacuum Transport assembly to make sure the
belts are moving.
Are the Vacuum Transport belts moving during printing?
Note: You can observe the belts through the front paper jam
door.
3
Remove all the print cartridges. Remove the vacuum
transport assembly and check for any signs of pieces of
media in the belts.
Is there any signs of media in the belts?
4
Check for any sings of torn belts, excessive toner buildup or
damage to the transport assembly especially to the
transport drive gear.
Are there any signs of broken or damaged parts in the
Vacuum Transport Assembly?
5
Check to make sure that the Vacuum Transport Assembly
drive gear meshes correctly with drive gear on the fuser
drive assembly.
Do the gears mesh correctly?
6
Check to make sure that the fuser drive assembly drive
gear to the vacuum transport is operating correctly.
Is the Fuser Drive assembly drive gear for the vacuum
transport operating correctly?
7
Check to see if the paper is laying flat on the vacuum
transport belts.
Is the paper laying flat on the vacuum transport belts as it
passes through the printer?
2-106
Service Manual
5060-XXX
Yes
Go to Step 3
Remove the
media from the
belts
Replace the
Vacuum
Transport
Assembly
Go to Step 6
Go to Step 7
Contact your
next level
support
No
Go to Step 5
Go to Step 4
Go to Step 5
Check both
the Fuser
Drive
Assembly and
Vacuum
Transport
Assembly to
make sure
they are
installed
correctly
Replace the
"Fuser
Assembly"
on page 4-16
Replace the
Vacuum
Transport
Assembly
Advertisement
Table of Contents
